Installing The Unit - Kenwood DNX8160DABS Quick Start Manual

Installation
Ñ Installation procedure
1) To prevent a short circuit, remove the key from the ignition
and disconnect the ¤ terminal of the battery.
2) Make the proper input and output wire connections for
each unit.
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and connect it to
the speaker connector in your vehicle.
5) Take Connector A on the wiring harness and connect it to
the external power connector on your vehicle.
6) Connect the wiring harness connector to the unit.
7) Install the unit in your car.
8) Reconnect the ¤ terminal of the battery.
9) Perform the Initial Setup. See Initial settings (P.5).

Installing the unit

Ñ DNX8160DABS, DNX5160DABS, DNX5160BTS,
DNX3160BT
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
24
Ñ DNX716WDABS
Screw (M5x6mm) (Sold
separately)
Car Bracket
Screw (M5x6mm) (Sold separately)
Ñ DNX516DABS
Screws (included in
genuine audio unit)
NOTE
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (eg, the sound may
skip).
Ñ Trim plate (DNX8160DABS, DNX5160DABS,
DNX5160BTS, DNX3160BT)
1) Attach accessory 5 to the unit.
Ñ Microphone unit
1) Check the installation position of the microphone
(accessory 3).
2) Clean the installation surface.
3) Remove the separator of the microphone (accessory 3),
and stick the microphone to the place shown below.
4) Wire the microphone cable up to the unit with it secured
at several positions using tape or other desired method.
5) Adjust the direction of the microphone (accessory 3) to
the driver.
3
Fix a cable with a commercial item of tape.
5