Stihl KM 56 R Instruction Manual page 10

English
2
1
Insert the square nuts (1) in the
N
barrier bar (2) – the holes must line
up
8
4
1
5
6
7
Insert the clamp (3) in the loop
N
handle (4) and position them
together on the shaft (5)
Position the clamp (6) against the
N
shaft
Position the barrier bar (2) – note
N
position!
Line up the holes
N
Insert the screws (7) in the holes
N
and screw them into the barrier bar
as far as they will go
Go to "Adjusting and Securing the
N
Loop Handle"
Always leave the barrier bar attached.
2
3
7
Orienting and Securing the Loop Handle
A
By changing the distance (A), the
handle can be moved into the best
position for the operator and application.
Secure the loop handle
N
Line up the loop handle
N
Tighten down the screws firmly –
N
lock the nuts if necessary
KM 56 R, KM 56 RC