Telephone Base Installation; Wall Mounting - VTech CS6114 Online User's Manual

Getting started

Telephone base installation

Install the telephone base as shown below.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service
through your telephone line, you must install a DSL filter between the
telephone line cord and telephone wall jack. The filter prevents noise and
caller ID problems caused by DSL interference. Contact your DSL service
provider for more information about DSL filters.
Telephone
wall jack
DSL filter (not included) is
required if you have DSL
high-speed Internet service
• Use only the power adapter supplied with this product. To order a
replacement, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
• The power adapter is intended to be correctly oriented in a vertical or
floor mount position. The prongs are not designed to hold the plug in
place if it is plugged into a ceiling, under-the-table or cabinet outlet.

Wall mounting

Your telephone comes ready for tabletop use. If you prefer to mount your
telephone on the wall (optional), it is designed to mount on a standard
telephone wall plate.
You can mount the telephone base on the wall by positioning the
top hole at the back of the telephone
base against the top mounting
stud [A]. Then slide the telephone
base down on the mounting
studs [A] and [B] until it locks
into place.
Telephone
line cord
Mounting
studs
Telephone base
[A]
[B]
2
Electrical outlet
(not controlled
by a wall switch)
Telephone base
power adapter
Telephone base