Download Print this page
Celestron StarSense Explorer LT 127 AZ Quick Setup Manual

Celestron StarSense Explorer LT 127 AZ Quick Setup Manual

Advertisement

Quick Links

127AZ
Quick Setup Guide
ITEM #22453
ENGLISH
5
Place the eyepiece accessory tray on top of the
tripod’s center leg brace. Thread the tray into the
threaded hole in the center of the leg brace until it
is fully seated.
NOTE: If necessary, rotate the accessory tray
counterclockwise until the accessory holes
are not covered by the leg brace arms as
shown here.
8
Tighten the altitude rod guide screw to hold the
telescope in place.
1
Unpack your telescope and verify that all parts
are present. Your StarSense Explorer LT includes:
a telescope tube with altitude slow motion rod
attached, a lens cap, an accessory bag, a tripod
with alt-azimuth yoke mount and center leg brace
attached, two tube mounting screws, a StarSense
smartphone dock, two eyepieces, a 2x Barlow
lens, an eyepiece accessory tray, a StarPointer
finderscope and StarSense Explorer app code card.
3
Extend the center portion of each of the three tripod
legs down about 6 to 12 inches. Use the tightening
screw on each leg to secure the extended leg in
place.
6
Loosen the knob on the altitude rod guide on the
side of the yoke mount so the hole is unobstructed.
9
Insert the two tube mounting screws through the
yoke mount and into the hubs on the telescope tube
to secure it in place.
2
To set up the tripod, spread the legs outward until
they are fully extended and push down the center
leg brace.
4
Check to ensure that all three legs are the same
height once extended to provide a level platform for
the telescope.
7
Slide the altitude rod
into the rod guide on the
mount and lower the altitude hubs on the telescope
tube into the cradles on the top of each yoke arm.
10
To install the finderscope, remove the two silver
nuts from the threaded posts on the top of the tube,
near the focuser.
ENGLISH | 1

Advertisement

loading

Summary of Contents for Celestron StarSense Explorer LT 127 AZ

  • Page 1 127AZ Quick Setup Guide Unpack your telescope and verify that all parts To set up the tripod, spread the legs outward until ITEM #22453 ENGLISH are present. Your StarSense Explorer LT includes: they are fully extended and push down the center a telescope tube with altitude slow motion rod leg brace.
  • Page 2 StarSense Explorer app to your mobile device. orange postcard in your telescope box. Launch the Search for “Celestron StarSense Explorer” in the app. When prompted, enter the activation code on Apple App Store or Google Play. The app is large, the postcard to activate the app.
  • Page 3 Moving the Telescope To move the mount left and right, loosen the azimuth Hold the tripod leg with one hand and grab the tension knob located on the yoke mount between telescope tube focuser and move it left or right two of the tripod legs.
  • Page 4 For more information on this product, please visit the respective product page on celestron.com SOLAR WARNING: Never attempt to view the sun through any telescope without a proper solar filter. Need assistance? www.celestron.com/pages/warranty Contact Celestron Technical Support celestron.com/pages/technical-support 08-19 4 | ENGLISH...

This manual is also suitable for:

22453