Table of Contents
Advertisement
STEERING
7. Install:
• Steering shaft 1
• Locknuts 2
• Joints 3
È Steering Shaft
É Set length
part number
8FA-23840-00
227.8 mm
(8.97 in)
NOTE:
Install the silver-colored end c of the joint 3 to the
steering column 1.
CAUTION:
Always use new cotter pins.
Steering shaft nut:
35 Nm (3.5 m · kg, 25 ft · lb)
8. Adjust:
• Skis
Adjustment steps:
• Temporarily install the handlebar.
• Hold the handlebar straight and check that the
skis and relay arms are at right angles to the
handlebar.
• Install the steering linkage alignment plate 1.
Steering linkage alignment plate:
90890-01487, YS-01487
• Loosen the locknuts (steering shaft) 2.
• Hold the handlebar straight.
• Adjust the steering shaft 3 by turning so that
the right and left relay arms point right under.
• Adjust each angle of right and left skis by turn-
ing the tie rod respectively.
Turning the steering
shaft in direction a
Turning the steering
shaft in direction b
• Tighten the locknuts (steering shaft) 2.
Steering shaft locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
LOCTITE
• Remove the steering linkage alignment plate 1.
40
CHAS
Ê Shaft
a
length b
169.8 mm
(6.69 in)
Turning the handlebar
in direction c
Turning the handlebar
in direction d
®
Advertisement
Table of Contents
