Table of Contents
Advertisement
R Right handlebar switch lead cou-
plers
S Thumb warmer adjustment
switch lead coupler
T Grip warmer lead connectors
U To the tail/brake light
V Headlight beam switch coupler
W Grip warmer adjustment switch
lead coupler
X Brake light switch lead coupler
Y Route the starter cable over the
left handlebar switch leads.
Z Auxiliary DC jack
[ Brake hose
\ Fuel sender lead coupler
] Fasten the ignition coil lead
under the fuel hoses with the
plastic band.
^ Fasten the fuel hoses with the
holders.
a Slide the boot completely over
the throttle position sensor cou-
pler, and then fasten the coupler
to the coolant hose 8 with the
plastic band.
b Cover the throttle position sensor
coupler and the throttle position
sensor leads that are not cov-
ered by the protector with the
boot.
c Starter relay
d Drive guard bracket
e Fasten the A.C. magneto lead
and wire harness with the plastic
band.
f Rectifier/regulator
g Fasten the headlight sub-wire
harness at the white tape with
the plastic band.
CABLE ROUTING
121
SPEC
Advertisement
Table of Contents
