Register; Handset Deregistration - Qwest 20-2432 Owner's Manual

Register

Register
Register Register Register

Handset Deregistration

Handset Deregistration Handset Deregistration
Handset Deregistration Handset Deregistration
You can deregister all Handsets at one time. This causes the Base Unit to 'forget'
that it has any Handsets at all. You may never have to perform this procedure.
One possible reason for deregistration is if you have the maximum number
of Handsets (8) registered to your Base, and one Handset should require
replacement, the Base will not register the 'new' Handset, because its eight
memory slots are occupied. The deregistration procedure will clear the Base
Unit's memory, and you will be able to register each Handset again. Individual
Handsets cannot be deregistered.
CAUTION: Once you deregister, your Handsets will not be capable of making CAUTION: Once you deregister, your Handsets will not be capable of making CAUTION: Once you deregister, your Handsets will not be capable of making CAUTION: Once you deregister, your Handsets will not be capable of making CAUTION: Once you deregister, your Handsets will not be capable of making
or receiving calls. You will need to re-register each Handset, one at a time!! or receiving calls. You will need to re-register each Handset, one at a time!!
or receiving calls. You will need to re-register each Handset, one at a time!! or receiving calls. You will need to re-register each Handset, one at a time!! or receiving calls. You will need to re-register each Handset, one at a time!!
To Deregister all Handsets: To Deregister all Handsets: To Deregister all Handsets:
To Deregister all Handsets: To Deregister all Handsets:
· At the Base Unit, in the idle (OFF) mode, press MENU.
· Scroll down to SETUP BASE
· Scroll down to DEREGISTER ALL
All system Handsets have been deregistered. To register your Handsets again,
see Registration and Operation Registration and Operation Registration and Operation, located in the Getting Started Registration and Operation Registration and Operation
User's Manual, for details.
Register Register Register Register Register
Use this option to register a Handset to the 20-2432
a total of eight Handsets to the 20-2432
automatically whenever a new handset is powered up in range of the 20-2432
Base.
You will be prompted to enter the 15-digit Base ID code. See Registration and
Operation Operation
Operation, located in the Getting Started Operation Operation
Note : Note :
Note : Base ID codes are 15 digits long and can include the following characters: Note : Note :
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, or * .
SETUP BASE, then press OK. SETUP BASE SETUP BASE
SETUP BASE
DEREGISTER ALL, then press SET. DEREGISTER ALL DEREGISTER ALL DEREGISTER ALL
20-2432 20-2432 Base. You can register 20-2432 20-2432
20-2432 Base. This process is activated 20-2432 20-2432 20-2432
Getting Started Getting Started
Getting Started Getting Started section of the manual, for details.
23
MENU. MENU. MENU. MENU.
OK. OK. OK.
OK.
SET. SET. SET. SET.
Getting Started Getting Started section of the Getting Started Getting Started
20-2432 20-2432 20-2432 20-2432
Registration and Registration and Registration and
Registration and