Trouble Shooting - MAGIDO GROUP X51 Series Operation And Maintenance Manual

MAINTENANCE AND REPAIRS

Trouble shooting

A number of possible inconveniences that may occur on the machine are listed below.
PROBLEM
CAUSE
1- The machine does not start
2- The pump does not start
3 – The heater does not heat
up
4 – The basket does not rotate
5 – Incomplete wash
6 – Pump leaks water
In case of electrical overload the pumps and motors may stops.
In this case re-engage the circuit breakers by pushing the ON button on circuit breaker itself.
In case of continuous anomaly have the cause verified by a qualified electrical technician
REVISIONE: X51-1213 EN
CAUSE
Main power supply fuses have blown
Bad connection between machine and
main power supply
Step down transformer fuse has blown
Timer has not been set
Circuit breaker not engaged *
Lid not close properly
Fuses F1 have blown
The thermostat is defective
Heater element burnt out
Weekly timer (optional) not set
Excessive load
Load not uniformly distributed
The spray nozzles are clogged
Pump rotates in the wrong direction
Filter is dirty or obstructed
Lower spray tube is not regulate
Basket brake is defective
Wash time too short
Wash solution too dirty
The spray nozzles are coggled
Filter is dirty or obstructed
Basket does not rotate
Pump rotates in the wrong direction
Not suitable detergent
Mechanical seal is worn
30
SOLUTION
Change
Reset
Change
Set
Engage
Close
Change
Change
Change
Set
Decrease the weight
Correct
Clean
Invert rotation
Clean
Set
Control
Increase time
Change solutions
Clean
Clean
See point 4
Invert rotation
Change
Replace
MAGIDO GROUP S.r.l.