Download Print this page

NEC PA721X User Manual page 215

Hide thumbs Also See for PA721X:

Advertisement

Common Problems & Solutions
Does not turn on
or shut down
Will turn off
No picture
Picture suddenly
becomes dark
Color tone or hue is
unusual
Image isn't square to
the screen
Picture is blurred
21
control is on. (
pages 13, 14)
room where you are presenting is particularly warm, move the projector to a cooler location.
of its life. If so, replace the lamp. After replacing the lamp, reset the lamp hours used. (
meters or higher. Using the projector at altitudes approximately 5500 feet/1600 meters or higher without
setting to [HIGH ALTITUDE] can cause the projector to overheat and the projector could shut down. If this
happens, wait a couple minutes and turn on the projector. (
If you turn on the projector immediately after the lamp is turned off, the fans run without displaying an image
for some time and then the projector will display the image. Wait for a moment.
Check if the appropriate input is selected. (
or one of the input buttons again.
If the HDMI input or the DisplayPort signal cannot be displayed, try the following.
- Reinstall your driver for the graphics card built in your computer, or use the updated driver.
For reinstalling or updating your driver, refer to the user guide accompanied with your computer or graphics
card, or contact the support center for your computer manufacturer.
Install the updated driver or OS on your own responsibility.
We are not liable for any trouble and failure caused by this installation.
on the power to the notebook PC.
In most cases the output signal from the notebook PC is not turned on unless connected to the projector
before being powered up.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver
or power management software.
218.
lower the internal temperature of the projector by selecting [HIGH] for [FAN MODE]. (
101)
page 19)
(
page 201)
Has the lens been shifted by an amount exceeding the guaranteed range? (
Should this happen, let the projector stand until there is no condensation on the lens.
page 161)
page 16) If there is still no picture, press the SOURCE button
page 93)
page 14)
page 93)
page 116)
page 108)
page 101, 111)
page 37)
page 108)
page 17)
page 22)
page 17)
page 205)
9. Appendix
page 116)
page

Advertisement

loading