Advertisement
Mounting the cable cover (sold separately)
appearance.
CAUTION
Mounting
1. Connect the power cord and cables to the projector (the connection cords are omitted from the diagrams).
2. Prepare a Phillips screwdriver.
1. Insert the two round protrusions on the left and right edges
of the cable cover into the grooves in the bottom of the
projector to line it up.
2. Turn the cable cover screw clockwise.
- Tighten the screw securely.
Removing
1. Turn the cable cover screw counterclockwise until it turns
loosely.
- Hold the cable cover while doing this to prevent it from
falling.
- The screw does not come completely off.
2. Remove the cable cover.
- Turn the cable cover a little, then lift it off.
199
9. Appendix
1
2
2
1
Advertisement
