Safety Instructions; Warnings - Ericsson RBS 2401 User Manual

2

Safety Instructions

This chapter shows the system used for presenting safety information.
Note:
Where local regulations exist, these are to be followed. The safety
information in this manual is a supplement to local regulations.
It is the responsibility of the local project manager to make certain that
local regulations are known and followed.
The relevant manual (including this safety information) and specific
instructions supplied by Ericsson must be followed in any work
performed on the Ericsson products or systems. A sufficient knowledge
of English or of any of the other languages in which the manuals or
instructions are printed is necessary.
The safety information in the relevant manuals presupposes that any
person performing work on Ericsson products or systems has the
necessary education, training and competence required in order to
perform that work correctly. For certain work, additional training or
special training may be required. For more precise information on the
amount and content of the general and/or special training required for
work on Ericsson products or systems, please contact the supervisor or
the local Ericsson company.
2.1

Warnings

Warnings are used to indicate hazardous activities. The warnings are
preceded by the common hazard symbol.
P002643
Figure 2
The following three warning levels, shown here in order of urgency, are
used:
LZN 302 14 P3A-1
1999-11-10
Reduce the risk of accidents by studying all the instructions
carefully before starting work. If questions arise regarding
the safety instructions, contact the supervisor or the local
Ericsson company.
Hazard symbol
Danger means that an accident may occur if the safety
precautions are neglected. This type of accident is likely to be
fatal.
© Ericsson Radio Systems AB
— All Rights Reserved —
DANGER
Safety Instructions
9 (158)