Table of Contents
Advertisement
Figure 15
72-inch Mower Deck
1. Blower assembly
2. Mower deck
3. Close the blower assembly to see if the latches are
adjusted correctly
(Figure
Note: Loosen or tighten the bolt so the latches firmly
hold the blower assembly against the mower deck but
can be released by hand.
Figure 16
1. Latch
2. Bolt
4. Install the spring as shown in
Note: Make sure that the hooks are in the correct
position.
3. Pivot hole
4. Blower-assembly peg
16).
3. Blower assembly
Figure
17.
1. Spring-loaded idler pulley
2. Short-hook end
5. Pull the spring-loaded idler pulley back and route the
belt around the mower-deck pulley
Note: Ensure that the belt is routed around the blower
pulleys correctly.
1. Mower-deck pulley
2. Spring-loaded Idler pulley
11
Figure 17
3. Long-hook end
(Figure
18).
Figure 18
3. Blower
Advertisement
Table of Contents
