Epson EMP-82 Setup Manual page 25

● Adjusting Position and Focus ●
(Setting up for the first time or after moving)
■ Raising the Projection Position (Adjusting the front foot)
When moving the projector, make
sure the front foot is retracted.
Correcting Keystone Distortion
You can adjust the vertical tilt to a maximum
of about 30°*.
Wide Top
* The greater the angle of tilt, the harder the
image is to focus. Setup the projector at a
lower angle of tilt.
■ Adjusting Focus
After keystone correction and
sharpness adjustments, the image
may be unfocused.
● Turning the Projector off ●
Turn off all connected equipment.
Press twice on the remote
control or control panel.
* If you turn the power on straight after turning it off, the time before projection starts becomes longer than usual.
Normal
Wide Base
Foot Adjust
Lever
You can adjust the front foot to raise the
projection angle up to a maximum of 10°.
• When the "Auto Keystone" function
is turned "Off" in the configuration
menu, automatic keystone
correction is not performed.
(EMP-82/62 only)
• You can also make keystone
corrections from the configuration
menu.
User's Guide "Settings Menu"
• Hold down
more than one second to reset the
correction value to the default
setting.
• Adjust the horizontal tilt by turning
the left rear foot.
Rear Adjustable
Foot
Extend
■ Adjusting Projection Size
Enlarge
After the confirmation buzzer beeps
twice, unplug the power cable.
Electricity is consumed if only the
projector's power is turned off.
Attach the lens cover.
and press for
Retract
Reduce
25