Data Reset; Copy Model Data; Rf Mode - Spektrum DX3.0 Manual

Data Reset

The Data Reset function allows you to reset all the programming in the selected model
(1, 2, 3 or 4) to the factory default settings and to copy model data from one model memory
System Mode
to another. Before using the Data Reset function, it's important to enter the Model Select
function and check to make sure the current model number indicated (1, 2, 3 or 4) is the
model which you want to reset to the factory default settings. The Model Select function is
described on page 16.
CLR
Accessing the Data Reset Function
1. Press the SCROLL and CHANNEL keys at the same time and hold.
2. Turn on the transmitter power switch to enter the System Mode.
3. Press the SCROLL key until CLR appears on the screen.
4. Press the INCREASE or DECREASE key at the same time to reset the data. To confirm
that the selected model's programming has been reset, a beep will sound and the model
number selected (1, 2, 3 or 4) will stop flashing.
5. Press the SCROLL key to access the Copy Model Data function.
6. To exit the System mode, either turn the transmitter power switch off or press the
SCROLL and CHANNEL keys at the same time.
Copy Model
CPY
Data
System Mode
Accessing the Copy model Data Function
1. Press the SCROLL and CHANNEL keys at the same time and hold.
2. Turn on the transmitter power switch to enter the System Mode.
3. Press the SCROLL key until CPY appears on the screen.
4. Press the INCREASE or DECREASE key to select the desired model number you want
the current model data copied to. The selected model number should be flashing.
5. Press the INCREASE and DECREASE keys at the same time to copy the current model
data into the selected model number. To confirm that the selected model has been copied
to, a beep will sound and the model number selected (1, 2, 3 or 4) will stop flashing.
6. To exit the System mode, either turn the transmitter power switch off or press the
SCROLL and CHANNEL keys at the same time.
20
I
Model to be Reset
2
Model being copied to

RF Mode

The DX3.0 features a selectable RF mode. N is the standard RF mode. FR is the France RF
mode and should only be selected if the transmitter is used in France.
Accessing the RF mode Function
To access the RF Mode function, follow the steps below:
1. Press the SCROLL and CHANNEL keys at the same time and hold.
2. Turn on the transmitter power switch to enter the System Mode.
3. Press the SCROLL key until RF appears on the screen.
4. Press the INCREASE and DECREASE keys to select the desired RF mode.
5. To exit the System Mode, either turn the transmitter power switch off or press the
SCROLL and CHANNEL keys at the same time.
RF
21