Check Network Ip Address (Windows 7 Or Xp) - Comfast CF-WR300N User Manual

This device is used for extending the wireless signal's
coverage of existing AP or wireless router. Under this mode, the
RJ45 wire port is being used as LAN port, computer can connect
with this device by wired or wireless signal. You should set your
computer's IP address manually or press the reset button for
restoration(note: after restoration, it is router mode by default,
the computer must through wireless way log in the setting page)
Application environments: Duplex houses, Large‐area places.
2.3 Router Mode
This device has wireless router function, its wired RJ45
port used as WAN port, it can connect with ADSL modem by web
cable, computer will get sharing network by connecting with
This device through wireless way.
Under this mode, the RJ45 wired port as WAN port, only through
wireless way the computer can connect with This device, device's
DHCP server is enabled by default, we suggest making the IP
address and DNS address acquired automatically.
Application environments: House, Apartments
Note: In most cases, the network of holes or school dormitories
adopt dynamic IP addressing, at this time, computer/wifi mobile
phone/pad only need make their IP address and DNS address
acquired automatically. In a few cases, the network is fixed IP
address, need make the computer/wifi mobile phone/pad's IP
address and DNS address same as the address which the network
administrator specified.
3、 Check network IP address(Windows 7 or XP)
Windows 7
1.Click"Start‐Control Panel‐Network and Internet‐Network and
sharing Center‐Change adapter settings‐Wireless Network
Connection", right click the wireless Network Connection, choose
"Properties"
2.Double click "Internet Protocol Version 4(TCP/IPv4)".
3. If your computer's IP address, sub net mask and default gateway
were set manually, please revise them to "Automatically get the IP
address and" Obtain DNS server address automatically then click
"OK", previous interface also click "OK"
Windows XP
1.Right click the "My Network Places" on the desktop and choose
"Properties"
2.Right click the "Wireless Network Connection" and choose
"Properties"
3.Double click "Internet protocol(TCP/IP)"