GE GFWNl100 Owner's Manual & Installation Instructions page 6

About the washer control panel.
Signal. ))
Cycle Signal
Usethe Signal pad to change
the volume of the end of cycle signal
Pressthe pad until you reach
the desired volume.
PreWash
il
Prewash (on some models)
Prewash is an extra wash before
the main wash. Use it for heavily soiled
clothes or for clothes with a care label
that recommends prewashing before
washing. Be sure to add high-efficiency
detergent, or the proper wash additive
to the prewash dispenser.
NOTE: When selecting prewash,
it is recommended to use powder
detergent in the main wash (detergent)
compartment.
Extra Rinse
Extra Rinse
Use an extra rinse when additional rinsing
is desired to remove excess dirt and
detergent from soiled loads.
Delay Wash
Delay Wash (on some models)
You can delay the start of a wash cycle
for !0-18 hours, depending on the model.
Pressthe Delay Wash pad to choose the
number of hoursyou want to delay
the start of the cycle,then pressthe Start
pad. The machine will count down and
start automatically at the correct time.
NOTE:If you forget to fully close the door,
a reminder signal will beep remindingyou
to do so.
NOTE:If you open the door when the delay
is counting down, the machine will enter
the pause state. You must close the door
and press Start again in order to restart
the countdown.
[(Lock6C_)]]
Hold 3 Seconds To
Lock/Unlock Controls
Lock
You can lock the controls to prevent any
selections from being made. Or you can
lock the controls after you have started
a cycle.
Children cannot accidentally start
the washer by touching pads with
this option selected.
To lock the washer controls, press and
hold the Lock pad for 3 seconds.
To unlock the washer controls, press
and hold the Lock pad for 3 seconds.
The control lock icon on the display will
light up when it is on.
NOTE: The Power
pad can still
be used
when the machine is locked.
My Cycle
Hold 3 Seconds To Store
My Cycle (on some models)
To savea favorite cycle,set the desired
settingsfor wash cycle,soil level, s pin speed
and wash temp settingsand hold down
the My Cyclepad for 3 seconds.A beep will
soundto indicatethe cyclehas been saved.
To useyour custom cycle, press the
My Cyclepad before washing a load.
To change the saved cycle, set the desired
settings and hold down the MyCycle pad
for 3 seconds.
NOTE: When using Ply Cycle, wash
options cannot be modified after the
cycle has been started.
NOTE:If you change wash options with
My Cyclebefore starting the cycle, the
My Cyclelight will turn off and you will
be returned to the base cycle.
6