Toro 07356 Installation Instructions Manual page 2

2. Install the 4 washers over the 4 hinge pins at the cab
frame for the machine (Figure 2).
3. Install the door onto the hinge pins mounted on the
cab frame (Figure 2).
Figure 2
1. Door
2. Hinge pins
4. Install the fitting at the rod end of the door strut onto
the ball stud at the cab frame (Figure 3).
3. Washer
4. Door-hinge mount
1. Ball stud (cab frame)
2. Fitting (strut rod)
Note: The door-fitting strut has a quick-release end.
Flip the lever vertically for installation. Once installed,
close the lever to capture the ball stud (Figure 4).
1. Lever
5. Install the fitting at the cylinder end of the strut onto
the ball stud at the door frame (Figure 3).
2
Figure 3
3. Fitting (strut cylinder)
4. Ball stud (door frame)
Figure 4