Stopping The Machine; Using The Parking Brake; Using The Implement Lift Lever - Toro Groundsmaster 120 Operator's Manual

2. Release the parking brake.
3. Slowly press on the upper pad of the traction pedal to
move forward (Fig. 9).
Driving Backward
1. To go backward, place your foot on the traction pedal
(Fig. 9).
2. Release the parking brake.
3. Slowly press on the lower pad of the traction pedal to
move rearward (Fig. 9).

Stopping the Machine

To stop the machine, release pressure on the traction
pedal, move the PTO switch to off and turn the ignition
key to off and remove the key. Also set the parking brake
if you leave the machine unattended; refer to Setting the
Parking Brake, page 17.
Caution
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Using the Parking Brake

Always set the parking brake when you stop the machine
or leave it unattended.
Setting the Parking Brake
1. Release pressure on the traction pedal to stop
movement.
2. Lift the parking brake lever up to apply the parking
brake (Fig. 10).
Releasing the Parking Brake
1. Move the parking brake lever down to the released the
parking brake (Fig. 10).
Figure 10
1. Parking brake

Using the Implement Lift Lever

The implement lift lever is used to raise and lower various
attachments (Fig. 10).
Note: When done using implement engage lock bracket
and tighten knob.
Raising Attachments
1. Remove pressure from traction pedal to stop the
machine.
2. Loosen the lock bracket knob. Move bracket back and
tighten knob (Fig. 11).
3. Pull implement lift lever rearward to raise attachment
to the desired height (Fig. 10).
Lowering Attachments
1. Remove pressure from traction pedal to stop the
machine.
2. Loosen the lock bracket knob. Move bracket back and
tighten knob (Fig. 11).
17
2
1
M–3155
2. Implement lift lever