Table of Contents
Advertisement
Quick Links
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
Part No. 104–7759
Loose Parts
Note:
Use the chart below to identify parts for assembly.
DESCRIPTION
Z–Stand hub
Bracket latch
Bolt, 3/8 x 1–1/2 in.
Lock nut, 3/8 in.
Z–Stand hub
Bolt, 3/8 x 3–1/2 in.
Lock nut, 3/8 in.
Hair Pin cotter
Clevis pin, 3 in.
Clevis pin, 2–5/8 in.
Printed in USA
Z–Stand Kit
Z–Master 100 Series
Part No. 105–1621
QTY.
1
1
Assemble 100 Series Z–Stand hub
1
1
1
2
2
2
1
1
The Toro Company – 2002
All Rights Reserved
FORM NO. 3326–318 Rev A
INSTALLATION
INSTRUCTIONS
USE
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Toro Z-Stand 105-1621
Summary of Contents for Toro Z-Stand 105-1621
- Page 1 Lock nut, 3/8 in. Z–Stand hub Bolt, 3/8 x 3–1/2 in. Lock nut, 3/8 in. Install 100 Series Z–Stand hub Hair Pin cotter Clevis pin, 3 in. Clevis pin, 2–5/8 in. The Toro Company – 2002 All Rights Reserved Printed in USA...
- Page 2 Installation Instructions DESCRIPTION QTY. Z–Stand foot Z–Stand tube Thrust washers Install 100 Series Z–Stand Lynch pin Hair pin cotter Clevis pin Z–Stand bracket Bolt, 5/16 x 2–3/4 in. Lock Nut, 5/16 in. Install 100 Z–Stand bracket Bolt, 1/4 x 3/4 in. Lock Nut, 1/4 in.
- Page 3 Installation Instructions Insert pivot pin into the Z–Stand hub as shown in figure 4. Note: When inserting the pivot pin, make sure the position of slot in tube is as shown in figure 3. Place a thrust washer onto the pivot pin and secure with a lynch pin (Fig.
- Page 4 Installation Instructions m–5357 m–5375 Figure 5 Figure 6 1. Z–Stand 4. Bracket Pin 1. Left front caster housing 5. Lock Nut, 1/4 in. 2. Latch 5. Bottom of slot 2. Z–Stand bracket 6. Bolt, 1/4 x 3/4 in. 3. Bracket 3.
- Page 5 Installation Instructions m–5374 Figure 8 m–5373 1. Z–Stand (Positioned in 2. Crack in side walk or turf Figure 9 slot) 3. Latch resting on pivot tab 1. Z–Stand 3. Locked position 2. Latch 4. Unlocked position 8. Drive onto stand. Stop when latch drops over tab into locked position (Fig.
- Page 6 Installation Instructions...
- Page 7 Installation Instructions...
- Page 8 Installation Instructions...
Need help?
Do you have a question about the Z-Stand 105-1621 and is the answer not in the manual?
Questions and answers