VocoPro SUB-1200 Instruction Manual page 9

Getting Connected
Connecting to an amplifier with no pre-amp outputs
If no low-level Pre-Amp outputs are available, you need to run speaker cables from your main amplifier to the
Sub-1200. Run the main LEFT and RIGHT speaker cables to the Sub-1200 HI-LEVEL IN binding posts. Be sure
to double check that the polarity (-/+) on the receiver or amplifier matches the polarity on the binding posts of the
SUB-1200. Also, make sure that the outputs on your main amplifier are true ground, otherwise you would short
the output of your main amplifier. Call or email technical support if the outputs on your main amplifier do not have
true ground.
0 PHASE 180
OFF AUTO ON
POWER
LEVEL
HI LEVEL OUT
LEFT RIGHT
+ - - +
115V
CAUTION
RISK OF ELECTRICAL SHOCK
230V
Connect to speakers
R
L
CROSSOVER
LINE OUT LINE IN
FREQUENCY
HI LEVEL IN
HI-LEVEL IN RIGHT
LEFT RIGHT
+ - - +
!
DO NOT OPEN
LA VERNE CALIFORNIA U.S.A.
WWW.VOCOPRO.COM
HI-LEVEL IN LEFT
SPEAKER OUT RIGHT
SPEAKER OUT LEFT
AMP
8