No Parts Required - Toro 07315 Installation Instructions Manual

Figure 10
1. Decal
3. Affix the decal to the dash panel, next to the switch
(Figure 10).
4. Locate the wire harness, with the loop back
connector, under the dash (Figure 11). The harness
will be labeled light switch.
Figure 11
1. Switch
5. Unplug the loop back connector from the harness
connector.
6. Plug the harness connector into the switch.
9
Installing the Hood

No Parts Required

Procedure
1. Connect the vehicle wire harness' to the main beam
and position lights.
2. Install the hood by reversing procedure 2.
2. Switch
2. Wire harness connector
10
Connecting the Negative
Battery Cable
No Parts Required
Procedure
1. Connect the negative battery cable to the battery.
2. Install the battery cover.
6