Position Light; Flasher; Clamp; Washer Face Thread Forming Screw - Toro 07315 Installation Instructions Manual

1. Old head lights
3. Plug a harness adapter onto each main beam.
4
Installing the Position Lights
Parts needed for this procedure:
2

Position light

Procedure
1. On the inside of the hood, locate the (3) dots under
each main light (Figure 3).
2. At each location, drill the following holes.
• At the center dot position, use a hole saw to drill
a 1–3/8 to 1–1/2 inch diameter hole (Figure 3).
• At the two outer dots, drill 1/4 inch diameter
holes (Figure 3).
Figure 2
2. New Main beams
1. 1/4 inch diameter holes
3. Secure a position light to the hood at each location
with (2) retainers (Figure 2). Position the lights with
the amber lens to the outside.
5
Installing the Flashers
Parts needed for this procedure:
2

Flasher

2

Clamp

1

Washer face thread forming screw

1

Washer

Procedure
1. Insert a flasher into each clamp (Figure 4).
3
Figure 3
2. 1–3/8 to 1–1/2 inch
diameter hole