Table of Contents
Advertisement
1. Signal controller
2. Nuts
2. Under the steering wheel, remove the two screws
securing the console to the steering pump (Figure 7).
1. Signal controller
2. Signal mount bracket
3. Using the two screws removed, secure the signal
mount bracket to the console/pump positioning as
shown in Figure 7.
4. Position the signal controller onto the signal mount
bracket and secure with two #6 lock nuts (Figure 7).
5. Route the signal controller wire harness down and
through the hole in the console (Figure 8).
Figure 6
3. Old screws
4. New screws
Figure 7
3. Locknuts
4. Console screws (2)
1. Wire harness
6. Locate the vehicle wire harness labeled signal
controller and plug it into the signal controller
harness.
8
Installing the Switch
Parts needed for this procedure:
1
Switch
1
Decal
Procedure
1. Remove a plug from one of the unused holes in dash
panel (Figure 9).
1. Plug
2. Insert the switch into the dash panel hole (Figure 10).
5
Figure 8
Figure 9
Advertisement
Table of Contents
