Operation; Emptying The Grass Basket; Clearing Obstructions From The Grass Catcher; Operating And Bagging Tips - Toro 79090 Operator's Manual

Easy-empty grass catcher for 825 rear engine riders
Table of Contents

Advertisement

Operation

To Avoid Personal Injury:
Become familiar with all operating and
safety instructions in the operator's manual
for your mower before using this
attachment.
Never remove the duct, basket, or chute
while the engine is running.
Always shut the engine off before clearing
an obstruction.
Never do maintenance or repairs while the
engine is running.

Emptying the Grass Basket

1.
Move the blade control to DISENGAGE (this
stops the mower blades), then back the mower
up to the area where you want to dump the grass
clippings.
2.
Stop the mower, shift to NEUTRAL, and shut
the engine off.
3.
Pull up on the dump handle and swing the grass
basket open.
4.
Empty the grass basket
5.
Close the grass basket completely and push the
dump handle down until it stops. Ensure that the
grass basket will not open.
Clearing Obstructions from the
Grass Catcher
1.
Stop the mower and shift to NEUTRAL.
6
2.
Raise the mower housing to the highest possible
position and slap the side of the duct near the
obstruction.
If the obstruction does not clear, complete the
following:
3.
Move the blade control to DISENGAGE (this
stops the mower blades). Shut the engine off
before you get off the mower.
4.
Check the grass basket and empty it if full.
5.
Remove and separate the duct and chute from
the grass basket and mower. Using a stick or
similar object, carefully remove and clear the
obstruction from the mower, duct, chute, and
grass basket.
6.
After you remove the obstruction, install the
complete grass catcher and resume operation.

Operating and Bagging Tips

Size
Remember that the mower is longer and wider with
this attachment installed. By turning too sharply in
confined places you may damage the attachment.
Trimming
Always trim with the left side of the mower. Do not
trim with the right side of the mower because you
could damage the chute and duct.
Cutting Height
Do not set the mower cutting height too low because
long grass surrounding the mower can prevent air
from getting under the mower and entering the grass
catcher. If enough air doesn't get under the mower,
the grass catcher will plug.

Advertisement

Table of Contents
loading

Table of Contents