Operation; Adding Water; Using Attachments - JET USA CLNSTMJETA1GR User Manual

Portable Steam Cleaner

Operation

Never use the steamer on persons or animals. • Do not use fragrances, chemicals or
detergents etc in the steamer tank – use fresh water only. • The steamer switches OFF
automatically if the water supply reaches the minimum level. • The steamer will automatically release
pressure if the steam temperature / pressure is excessive. • Do NOT overfill the tank – always fill it to
between 150 and 270ml. • Always use the correct attachment for the surface being cleaned. For example, do
not use the hard brush for delicate surfaces or paint etc.
The high-temperature steam action enables general cleaning of virtually any surface (hard surfaces, delicate
items, fabrics etc), killing bacteria and leaving surfaces sterilised. The product is also useful for removing
stains and eliminating odours, removing creases from fabrics, and air purification.
Several attachments are supplied for various tasks, such as the flexible extension nozzle for hard to reach
places, brushes for fabrics, and the steamer cloth for hard surfaces such as floors.
The steamer can be used as a room humidifier also. When used in this manner, keep the steamer well out of
the reach of children etc, and be aware of having to replace the water in the steamer.

Adding Water

1. Disconnect the appliance from the
electrical supply.
2. Press the steam button (A) to release
any remaining steam. Release the
button when no steam can be seen
escaping from the unit.
3. Partially open the cap (B), then allow
the appliance to cool for 5 minutes.
4. Remove the cap fully.
5. Use the funnel and measuring cup to add 150 to 270ml of water.
6. Re-install the cap and tighten it firmly by hand.

Using Attachments

• The general purpose nozzle, flexible extension or large
surface attachment can be connected directly to the
appliance.
• The general purpose nozzle or large surface attachment can
be connected to the flexible extension.
To attach the above, align the attachment up with the "bayonet"
fitting, push it on then rotate right (clockwise) to lock the
attachment on. To remove, rotate the attachment left (anti-
clockwise) to unlock it, then pull it from the bayonet fitting.
General Purpose Nozzle
E&OE
Large Surface Attachment
© 2019 Jet-USA
Push on then twist to install
Flexible Extension
6