Portable Steam Cleaner
•
The adaptors, brushes etc can be attached to the general purpose nozzle.
•
The mop or glass cleaning attachment connects to the large surface
attachment.
To attach the adaptors or brushes, push them firmly onto the end of the
nozzle.
Brush
To attach the glass cleaning attachment, clip it to the large surface attachment.
To attach the steamer cloth, wrap it around the large surface attachment.
Glass Cleaner
General Use
1. Fill the appliance with water and attach the required attachment as described above.
2. Connect the appliance to the electrical supply – the indicator on the side of the appliance illuminates to
show it is heating. Allow approximately 4 minutes for initial heating.
3. Press the steam button as required. For continuous use, press the steamer button down then pull back
on it slightly until it locks in the steaming position. To stop continuous operation, push the button forward
to unlock it.
After Use
1. Disconnect the appliance from the electrical supply.
2. Press the steam button to release any remaining steam. Release the button when no steam can be seen
escaping from the unit.
3. Partially open the cap, then allow the appliance to cool for 5 minutes.
4. Remove the cap and drain the appliance. Leave the cap off to allow any remaining water in the
appliance to evaporate.
5. Re-install the cap.
E&OE
Steamer Cloth
© 2019 Jet-USA
Push on to install
7