Operation; Steps - JET USA S1000G User Manual

Portable Steam Cleaner

Steamy Skin Care!

Connect the terminal of the plastic veil, press the steam button, then switch on the current and the steam
cleaner will gradually produce and release steam.
ATTENTION:
The rated water capacity can't be over 180ml when you are operating this function.


In order to avoid your face being scalded by spurting water, you should put a small cotton
handkerchief into the veil to prevent water from spurting.

When you are using steam to care for your face, you should alternately move your face from the
steam cleaner from far to near and vice-versa. Your face also can't be lower than 40cm from where
the steam is being released.

You should spend no more than five minutes every time for your face care.
The special magnetic veil is designed based on the principal of a sauna and is connected to a magnetic
material. As the steam goes through the magnetic material, the active ions in the steam becomes
magnetically-charged. This steam can speed up the metabolism of our skin and blood circulation. It can
also strengthen osmosis and absorption. It activates the epidermal cells, promoting one's libido and
metabolism. It can make your skin smoother and more exquisite.
You can also use medicine as fumigation while caring for your skin (put the medicine into the veil).
Please operate this function with a beautician's instructions.

Operation

Steps

1. Open the package, check for all the parts and manuals, and make sure that no component is missing in the
package.
2. Please read the manual before using the steam cleaner. This product is only for household usage.
3. Put the steam cleaner on the table, remove the safety cover, and insert the funnel.
4. Use a measuring cup to get 150ml – 270ml of water (about one and a half cup), add it into the tank, then put
the safety cover back and screw it firmly.
5. Check the electric current and plug, make sure that they match the requirements in the manual, then insert
the plug.
6. Steam will be ready after four minutes of heating. Press the steam button slightly to see if the steam starts to
release.
7. Release the button; insert different parts according to different usage.
8. Press the steam button again; then start cleaning.
5