Advertisement
How to Use Your Vax VS-03R
Assembling the Appliance
Fig.1 The telescopic extension tubes can be lengthened by pressing the button & sliding the
inner tube to required length.
Fig.2 To attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible
hose into the attachment point on the vacuum cleaner.
Adjusting the cleaning tool for carpets & hard floors
Fig.3 Hard floor position (tiles, parquet floors, etc.) - The cleaning tools brush must be in the
lower position. Press on the rocker switch to lower it.
Fig.4 Carpet or rug position - The cleaning tools brush should be raised.
Press the rocker switch to lift the brush up.
Getting started
Fully extend the mains cable but not beyond the yellow marker and plug it into a
standard domestic outlet
4
Fig.5 Press the foot pedal to start the vacuum cleaner. To stop it press the pedal again.
Fig.6 Press the foot pedal to recoil the power lead. NOTE: Guide power cord with one hand.
Fig.7 The hose grip has buttons for control of suction power.
Fig.8 Vacuum power can be adjusted electronically by pressing one of the buttons on the
Auto - for normal vacuuming of carpets and hardfloors.
Min - for curtains - soft furnishings.
Max - for very dirty carpets or carpet with high pile.
Using the accessories
Fig.9 Open the accessory storage compartment (fig. 9a). These accessories can be fitted
ON/OFF
MAX
MIN
AUTO
Fig.10
Fig.11 & 12 You can move or store your appliance in a vertical position by sliding the hook on
Rewind 1-1
1
/
metres of cord at a time. This will prevent the cord from whipping
2
which could cause damage or injury.
handle (fig.7).
directly to the tubes or onto the end of the flexible hose handle. The small cleaning tool
is used for upholstered furniture. The crevice nozzle is ideal for cleaning awkward places
such as behind radiators, skirting boards and hard to reach areas. The brush attachment
is designed for dusting.
If you wish to pause briefly during vacuuming i.e. to move a piece of furniture or
a rug, use the special parking position on your vacuum cleaner. Slide the hook
attached to the large cleaning tool into the slot on the rear of the appliance. When
you have finished vacuuming, press pedal to stop the appliance then unplug it at
the mains. Press the pedal to automatically rewind the cord (See note fig.6).
extension tube into the clip on the underside of the appliance.
This practical system allows you to carry the vacuum cleaner around in one hand
and provides minimum storage space.
5
Advertisement
