Reversing The Doors - Beko FRFP1685X User Manual

Reversing The Doors

We recommend that you reverse the
door before switching on for the first
time.
Tools required: Small and medium size
flat and cross-headed screwdrivers, a
pair of pliers.
Spare Parts supplied in the plastic
bag: The following parts, which are
exclusively for left hand side fitted
hinge operation are supplied in a
plastic bag with the appliance:
- Door top trim hinge covers – there
are 2 different parts, one for each side
of top trim.
We suggest you keep all the parts
supplied in the plastic bag and also
parts, which have been removed when
reversing the door, in a safe place for
possible future, re-use.
Important:
We suggest you ask somebody to
help you when moving the appliance
around and to hold the door when
removing / re-fitting hinges and the
door to avoid any injury and damage
to the product.
Please refer to diagrams supplied.
To follow numbers in brackets below,
refer to the main diagram.
1. Switch off the appliance at the
socket outlet and pull out the mains
plug.
2. Remove all loose items and
fittings and food inside the appliance.
3. Gently prise off plastic hinge
covers on both sides of front top
panel using a small flat-headed
screwdriver. (1-2)
4. Unscrew the bolts of the top
hinge and remove top hinge. (3)
5. Remove door carefully off the
bottom hinge and stand door upright
in a safe place.(4)
6. Gently prise off plastic hinge
cover on door top trim. Fit the other
door top trim plastic off hinge cover
supplied in the plastic bag.(5)
7. Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this.
you tilt the appliance back, check to
make sure the appliance is completely
stable and safe before you carry
on. (6)
8. Unscrew and remove the front
feet and 1 bolt. (7)
9. Unscrew and remove the
bottom hinge. (8)
10. Unscrew and remove the
bottom hinge door stopper and
bushing and reposition them on the
other side while rotating
bushing 180°. (9)
11. Fit the bottom hinge and
tighten the screws as shown in figure.
(10)
12. Fit the other front feet as
shown in figure. (11)
13. Rotate the top hinge 180°.
Unscrew the hinge pin and re-tighten
it to the opposite side. (12)
14. Fit the top hinge on the left
hand side bushing of the door. (13)
15. Locate and re-fit door to
bottom hinge pin. (14)
16. Re-fit the upper hinge on the
opposite side by using a flat headed
screwdriver. (15)
10
EN
Once
the