Cisco Catalyst 3750-X Series Getting Started Manual page 5

Step 6 Connect a Category 5 Ethernet cable to a port:
Any 10/100/1000 Ethernet port on the switch front
•
panel
The RJ-45 management port on the switch rear panel
•
Connect the other end of the cable to the Ethernet port on
your PC.
Wait until the port LEDs on the switch and your PC or
laptop are green or blinking green. Green LEDs mean a
successful connection.
Troubleshooting:
If the port LEDs do not turn green after about 30 seconds,
make sure that:
You connected the Ethernet cable to one of the
•
downlink switch ports (not to the console port).
You are using an undamaged Category 5 or 6
•
Ethernet cable.
The other device is turned on.
•
Step 7 Start a browser session on the PC, and enter the IP address 10.0.0.1. When prompted, enter the default password,
cisco.
The switch ignores text in the username field.
Note
The Express Setup window appears.
Troubleshooting:
If the Express Setup window does not appear, make sure that any browser pop-up blockers or proxy settings are
disabled and that any wireless client is disabled on your PC or laptop.
OL-19590-01
MODE CONSOLE
SYST
EN XPS STAT
S-PWR SPEED DUPLX
MAST STACK
PoE
1 2
3 4
5 6
7 8
9 10 11
12
1 2 3
4 5
6 7 8
9 10
11 12
1 2
3 4
5 6
7 8 9
10 11 12
1 2 3
4 5
Catalyst 3750-X and 3560-X Switch Getting Started Guide
Running Express Setup
C3KX -NM-1 NETW ORK
0G MODU LE
6
7 8
Cataly st 9 10
3750-X 11 12
PoE+4 8 G1
G2/TE 1
G3
G4/TE 2
5