Cisco Catalyst 3750-X Series Getting Started Manual page 4

Running Express Setup
Step 3 Power the switch.
AC power switches: Plug the AC power cord into the
switch power supply and into a grounded AC outlet.
DC power switches: See the wiring instructions in the
hardware installation guide on Cisco.com.
Step 4 Approximately 30 seconds after the switch powers on, it begins the power-on self-test (POST), which can take up to
5 minutes to complete.
During POST, the SYSTEM LED blinks green, and the XPS, STATUS, DUPLEX, and SPEED LEDs turn solid
green.
When POST is complete, the SYSTEM LED is green, the MAST LED is green if the switch is acting as stack master,
and the other LEDs turn off.
Before going to the next step, wait until POST is complete.
Note
Troubleshooting:
If the SYST LED blinks green, does not turn green, or turns amber, contact your Cisco representative or reseller. The
switch failed the power-on self-test (POST).
Step 5 Press and hold the Mode button until all the LEDs next to
the Mode button turn green. (The XPS LED remains off
on some switch models.)
You might need to hold the button for more than 3
seconds.
The switch is now in Express Setup mode.
Troubleshooting:
If the LEDs next to the Mode button blink when you press
the button, release it. Blinking LEDs mean that the switch
is already configured and cannot go into Express Setup
mode. For more information, see the
Switch to the Default Settings" section on page
Catalyst 3750-X and 3560-X Switch Getting Started Guide
4
"Resetting the
20.
CONS OLE
AUX
STA CK RESE T
1
STA CK
2
S-PW R
RPS AC OK
PS OK
C3K-P WR-7
15WA C
AC OK
PS OK
S-PW R C3K-P WR-7
15WA C
MODE CONSOLE M O D E
CO NS O
SYST RPS
EN STAT
S-PWR MAST SPEED DUPLX LE
STACK
PoE
1 2
3 4
5 6
7 8
9 10
11 12
13 14
15 16
17 18
19 20
21 22
23 24 C3KX -NM-1 NETW ORK
25 26 0G
27 28 MODU LE
29 30
31 32
33 34
35 36
37 38
39 40
41 42
43 44
45 46
Cataly st 3750-X 47 48
PoE+4 8
G1
G2/TE 1
G3
G4/TE 2
OL-19590-01