Satcube Ku User Manual page 39

• LAN interface and USB interface
The LAN and USB connections are located at the front left side of the terminal, covered by a
plastic protection.
1
Figure C2 LAN and USB interfaces.
Port
1 100 Mbps Ethernet
2 100 Mbps Ethernet
3 USB
• L-band interface
An L-band interface is available on the backside of the antenna, located at the top right. The
interface consists of two SMA connectors with an impedance of 50 ohm. One of which allows
to connect to the transmit port of the BUC, the Tx connector. The second connector, Rx
connector, allows the connection to the output of the LNB. These can be used to connect
external modems that works in the
L-band, external signal generators or spectrum analyzers. The connectors are protected
behind a plastic cover fastened with two torx T10 screws.
Figure C3a L-band interface, covered.
2
3
Type
SATCUBE PROPRIETARY
Satcube Ku User Manual v2.0-2019
Figure C3b L-band interface, 50 ohms
SMA connectors exposed.