• Keep this manual for future reference. by means other than an approved Masterbuilt accessories or solid, non-fl ammable surface under the base; • WARNING! Do not use spirit or petrol for lighting or re-lighting! Use only fi relighters complying to commercial use;...
Grilling Guide WARNINGS AND IMPORTANT SAFEGUARDS BEEF SIZE GRILLING TIME INTERNAL TEMP • Keep grill clear and free from combustible materials such as gasoline and other fl ammable vapors and 3-4 min./side Med. rare 62°C liquids. Steaks 2cm thick 4-5 min./side Med.
Structural Proximity and Safe Usage Recommendations Operating Instructions REMINDER: Maintain a LIGHTING YOUR GRILL minimum distance of 10 1. Raise the cooking grate, open the charcoal door and open air feet from rear and sides to Fig. A dampers. Dump charcoal into walls, rails or other charcoal tray as 2.
MASTERBUILT Customer Service at +44 20 8036 3201 or service.uk@masterbuilt.com in STOP the U.K and +0031 4 7799920, +49 2151 4474509, or service.europe@masterbuilt.com in Europe. Please have the model number and serial number available. These numbers are located on the...
Parts List Assembly Actual product may differ from picture shown. Item # Qty Description Item # Qty Description Cooking Grate Rear Frame Wheel Axle Cooking Grate Wheel Cooking Grate Front Frame with Handle Cart Bottom Shelf Smoke Stack Cap Cart Front Panel Smoke Stack Cart Rear Panel Temperature Gauge...
Page 7
Assembly Assembly Note: Do not fully tighten screws until step 11 is complete. To avoid personal injury and damage to grill, have someone help you position the charcoal door into the hinges and hold it steady until hinge and cotter are installed.
Page 8
Assembly Assembly Note: Do not fully tighten screws until step 11 is complete. Left Front Leg Note: Do not fully tighten screws until step 11 is complete.
Page 9
Assembly Assembly Note: After completing step 11, fully tighten screws from steps 1, 3, 4 and 8.
Page 10
Assembly Assembly Washer Wing Nut To avoid personal injury and damage to grill, have someone help you lift the lid/fi rebox assembly and place onto the cart. Your helper should hold the lid/fi rebox assembly steady until all screws are installed. Note: Do not fully tighten screws until step 11 is complete.
Need help?
Do you have a question about the MB20042119 and is the answer not in the manual?
Questions and answers