S5500-28F-Ei - H3C S5500-EI Series Installation Manual

(3) Grounding screw
(5) Interface card slot 2 (MOD2)
NOTE:
The S5500-52C-EI is shipped with the two expansion interface card slots covered by filler panels. You can
select one or two interface cards for your switch as needed. For the interface cards available for the
S5500-EI Switch Series, see
removing an interface

S5500-28F-EI

Figure 6 Front panel of the S5500-28F-EI switch
(1) SFP port
(3) 10/100/1000 Base-T auto-sensing Ethernet
port
(5) Console port
(7) Interface card 1 status LED (MOD1)
(9) System status LED (SYS)
(11) Hot swappable power module 2 status LED
(PWR2)
(13) Seven-segment LED
Figure 7 Rear panel of the S5500-28F-EI switch
(1) Grounding screw
(3) Hot swappable power module 2 (a PSR150-D)
(5) Interface card slot 2 (MOD2)
"Interface cards." For how to install an interface card, see
card."
6
(4) Interface card slot 1 (MOD1)
(3)
(2)
(1)
(2) SFP port status LED
(4) 10/100/1000 Base-T auto-sensing Ethernet port
status LED
(6) Port status LED mode switching button
(8) Interface card 2 status LED (MOD2)
(10) Hot swappable power module 1 status LED (PWR1)
(12) Port mode LED (Mode)
(2) Hot swappable power module 1 (a PSR150-A)
(4) Interface card slot 1 (MOD1)
"Installing and
(4) (5) (6) (7)
(8)
(9)
(10)
(11)
(13) (12)