Advertisement
Quick Links
Dual rack mount net5501
Quick Start Guide
Thank you for purchasing a dual rack mount net5501 server.
Your package should contain:
1RU server case
Cover plate and hex screws for empty board slots
Optional Extras
1 or 2 x mounting kits to suit the net5501 board
punched cover plate, 2 x hex screws, hex key, board mounting plate, 7 x
➢
M3 x 5 screws, 1 x M3 x 12 screw, 1 metal spacer, 2 x serial port screws
1 or 2 x net5501 boards
Please read the following instructions to begin using your dual rack mount net5501.
© Yawarra Tiny Computers
April 2014
Advertisement
Related Manuals for Yawarra net5501
Summary of Contents for Yawarra net5501
- Page 1 M3 x 5 screws, 1 x M3 x 12 screw, 1 metal spacer, 2 x serial port screws 1 or 2 x net5501 boards Please read the following instructions to begin using your dual rack mount net5501. © Yawarra Tiny Computers April 2014...
- Page 2 Install the boards into the server case (optional) If your boards are not installed in the rack mount net5501, you may need to do the following: 1. Remove the five (5) screws from the top of the case and remove the top of the case.
- Page 3 7. Tighten the 4 M3 x 5 screws that hold the assembly to the base of the rack mount case. 8. Connect the PCI card to the net5501 using the flexible PCI riser, with the ribbon cable extending upwards from the connectors at both ends.
- Page 4 Install a 2.5” hard drive (optional) If you want to install a hard drive in your net5501, you will need to use a net5501 hard drive mounting kit. Please note that you will need to remove the hard drive to access the miniPCI slot on the net5501 board.