Download Print this page

Yawarra nuxV 1600 Quick Start Manual

Dual rack mount

Download this manual

Dual rack mount nuxV 1600

Quick Start Guide

Thank you for purchasing a dual rack mount nuxV 1600 server.

Your package should contain:

1RU server case



Cover plate and hex screws for empty board slots



Optional Extras

1 or 2 x mounting kits to suit the nuxV 1600 board



punched cover plate, 2 x hex screws, hex key, board mounting plate, hard

➢

drive mounting plate, CPU heat bridge, 13 x M3 x 5 screws, 4 x M3 x 16

brass standoffs, 2 x serial port screws, data cable, power cable

1 or 2 x nuxV 1600 boards (plus 1 x power supply per board)



Please read the following instructions to begin using your dual rack mount nuxV 1600.

April 2014

Page 1 CPU heat bridge, 13 x M3 x 5 screws, 4 x M3 x 16 brass standoffs, 2 x serial port screws, data cable, power cable 1 or 2 x nuxV 1600 boards (plus 1 x power supply per board) ...
Page 2 Step 1 Install the boards into the server case (optional) If your boards are not installed in the rack mount nuxV 1600, you may need to do the following. If you are installing a miniPCI card as well, you may want to do that first (go to Step 3).
Page 3 Configure and install a Compact Flash card To use your rack mount nuxV 1600, you will need to have either a CF card or a 2.5” hard drive with a suitable operating system installed. To install a hard drive, refer to Step 1.
Page 4 The board will go through its boot up cycle, which you can watch if you are connected to the serial console. Your rack mount nuxV 1600 is ready to use! Contact us Please feel free to contact us if you have any queries regarding your rack mount nuxV 1600. Yawarra Tiny Computers Website www.yawarra.com.au Email enquiries@yawarra.com.au...