Advertisement
Figure 14
1. Carriage bolt
2. Bracket
3. Light assembly
6.
Connect the wire harness to the to the light
assembly and secure it with the wire anchors
(Figure
15).
Figure 15
1. Wire harness
7.
Remove the plug-cover and insert the switch
assembly into the panel opening until it is secure
(Figure
16).
g033547
4. Washer
5. Nut
g033549
2. Wire anchor
1. Decal
8.
Apply the decal to the panel as shown in
16.
9.
Connect the accessory-wire harness to the
switch assembly.
10.
Connect the negative (-) battery cable.
11.
Turn the lights on. Refer to
(page
6).
12.
Aim the lights according to your local regulations.
13.
Install the roof onto the cab with the 22 screws
previously removed
14.
Torque the screws to 10.1 to 12.4 N∙m (90 to
110 in-lb).
Operation
Operating the Light
•
Push the O
portion of the switch to turn the lights
N
on.
•
Push the O
portion of the switch to turn the
FF
lights off.
6
Figure 16
2. Switch assembly
Operating the Light
(Figure
1).
g033598
Figure
Advertisement
