Advertisement
1. Wire-harness connector
8.
Remove the plug-cover and insert the switch
assembly into the panel opening until it is secure
(Figure
8).
1. Switch assembly
9.
Connect the wire harness to the switch
assembly.
10.
Connect the negative (-) battery cable.
11.
Turn the lights on. Refer to
(page
6).
12.
Aim the lights according to your local regulations.
13.
Use the bolts and nuts that you set aside earlier
to secure the headliner to the cab
14.
Install the roof onto the cab with the 22 screws
previously removed
15.
Torque the screws to 10.1 to 12.4 N∙m (90 to
110 in-lb).
Figure 7
Figure 8
Operating the Light
(Figure
(Figure
1).
Installing the Light to a 2 Post
ROPS Extension
Note:
Ensure that your machine is equipped with the
optional accessory-wire harness installed. Contact
your authorized Toro distributor if your machine
requires the accessory-wire harness.
1.
Install the light mount to the bracket.
•
For a machine with mirrors: Use the 4 bolts
(6 mm x 20 mm) to secure the light assembly
through the bracket and to the mirror mount
(Figure
g033595
1. Mirror mount
2. Bracket
•
For a machine without mirrors: Use the
4 bolts (1/4 x 7/8 inch) and flange nuts to
g033743
secure the light assembly to the bracket
(Figure
1).
1. Bolt (1/4 x 7/8 inch)
2. Bracket
4
9).
Figure 9
3. Bolt (6 mm x 20 mm)
10).
Figure 10
3. Flange nut (1/4 inch)
g313878
g033741
Advertisement
