Installation & Wiring 2.1; Unpacking 2.2; Location 2.3; Mounting 2.4 - Partlow MRC 7800 Installation, Wiring, Operation Manual

Installation & Wiring 2.1
CAUTION: The Instrument AC power input is as specified in the model number; 115VAC or 230VAC. Verify the AC power
input provided with the instrument prior to proceeding with installation.
Read these instructions carefully before proceeding with installation and operation. Electrical
code requirements and safety standards should be observed. Installation should be per-
formed by qualified personnel.

Unpacking 2.2

Remove the unit from the carton and inspect it for any damage due to shipment. If any
damage is noticed due to transit, report and file a claim with the carrier. Write the model
number and serial number of the unit on the inside of the front cover of this Operation Manual
for future reference when corresponding with the factory.

Location 2.3

Locate the instrument away from excessive moisture, oil, dust, and vibration. Do not subject
the instrument to operating temperatures outside of 0 to 55° C.

Mounting 2.4

Figure 2-1 (page 8) shows installation view and physical dimensions for a panel mounted
unit.
The panel that the unit will be mounted in must provide rigid support for the approximately 20
pound unit . Adjacent units may be mounted within a minimum of 2 inches horizontally and 3
inches vertically, providing that proper panel support is supplied.
PANEL MOUNTING HARDWARE REQUIRED: (not provided with instrument)
PANEL MOUNTING:
1) Cut panel hole to dimensions shown in Figure 2-1 (page 8).
2) If the rear of the panel is accessible for wiring after mounting, place the unit in the
panel cutout and fasten it to the panel through mounting holes supplied in the case
flange.
3) If the rear of the panel is not accessible for wiring, proceed with wiring preparation and
wiring, then mount the unit.
SURFACE MOUNTING:
1) If surface mounting is required, use Kit # 64402001 (ordered separately) Install mounting
brackets on sides of case and mount on the mounting surface.
(4) 9/32" x 2" bolts w/nuts
(4) appropriate lockwashers
P 7
AGE