Configuration Introduction 4.1 - Partlow MRC 7800 Installation, Wiring, Operation Manual

P 18
AGE

Configuration Introduction 4.1

After completing installation of the unit, the configuration procedures contained within this
section must be performed to prepare the unit for operation on the intended application. The
procedures include selecting specific parameters, entering data and possible jumper position-
ing.
Parameter selections and data entry are made via the front keypad. To ease configuration
and operation, user entered data has been divided up into several modes. Each mode
contains a different type of data or may be used for specific operating functions. For two pen
instruments, each mode is common to both pens. These modes are as follows:
Mode Display Code
Off oFF
Operation oPEr
Prog
Program
Alarm Set ASEt
Data logger dLS
Setup
Data logger dLd
Display
Preset PSA
Adjust
Test tESt
Calibration CAL
Enab
Enable
Associated with each mode is a series of unique displays which are accessed via the front
keypad.
Prior to first time operation of the unit, the configuration procedures for the Program, Preset
Adjust, Data logger Setup, and Alarm Set modes must be performed as applicable.
Calibration and Test modes are not used as part of the unit configuration or operation. These
are used for service and maintenance functions and are discussed in detail in Section 5.6 of
this manual (page 40).
Function Description
Operation Alarm Outputs off, Totalization off
Operation Operation
Configuration Configure operating parameters
Configuration Set alarm settings
Configuration Adjust/set real time and log time
Operation View logged data
Operation Adjusts, sets preset values
Service Perform unit tests
Service Perform unit calibration
Configuration Lockout or enable access to any
mode