Table 7. Serial Configuration Command Code - Wiznet WIZ1000 User Manual

Command Parameter
RY PPPoE ID
RZ PPPoE Password
RI IP Address
RS Subnet Mask
RG Gateway address
RP Local Port Number
RD 0 : Static, 1 : DHCP, 2 : PPPoE
RM 0 :TCP Client, 1 :TCP Mixed, 2 :TCP Server
RK 0 : TCP, 1 : UDP
XXXX
eg. [Baudrate]1: 115200, 2: 57600,
3: 38400, 4: 19200, 5: 9600,
RB 6: 4800, 7: 2400,8: 1200
[data byte] 7 : 7bit, 8bit
[parity] 0 : no parity, 1 : Odd, 2 :Even
[Flow] 0 : no, 1 : Xon/Xoff, 2 :RTS/CTS
RT 0 : Disable, 1 : Enable
RE xxxxxx (eg. In hex format : 2B 2B 2B)
RF x.x (eg. 3.1)
RX xxx.xxx.xxx.xxx (eg. 192.168.11.144)
RN 0~65535
QC XX
QS 0~255
QT 0~65535
QI 0~65535
Copyright © WIZnet All Rights Reserved

Table 7. Serial Configuration Command Code

Comments
PPPoE ID Check
PPPoE Password Check
Get Local IP
Get Subnet mask
Get Gateway
Get Local IP's port number
Get the IP configuration method
Get the operation mode
Get the Protocol
Get the serial baud rate
Get the serial command method
Get the command mode character
Get the firmware version
Get the server IP address
Get the server port number
Get delimiter character in hex
Get delimiter size
Get delimiter time
Get Inactivity timer value
WIZ1000 | 27 page