Table of Contents
Advertisement
Available languages
Available languages
The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL
SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper inter-
pretation of these symbols will allow you to operate the product better and safer.
SYMBOL
Safety Alert
Read Operator's Manual
Eye Protection
Wet Conditions Alert
Recycle Symbol
V
Volts
min
Minutes
Direct Current
n o
No Load Speed
.../min
Per Minute
SYMBOLS
MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or
serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or
moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but
not related to a potential injury (e.g. messages relating to property damage).
NAME
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand opera-
tor's manual before using this product.
Always wear eye protection with side shields marked to comply
with ANSI Z87.1.
Do not expose to rain or use in damp locations.
This product uses lithium-ion (Li-ion) batteries. Local, state or
federal laws may prohibit disposal of batteries in ordinary trash.
Consult your local waste authority for information regarding avail-
able recycling and/or disposal options.
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
DESIGNATION/EXPLANATION
5 - English
- Quick Links:
- Symbols
- Operation
- Assembly
- Maintenance
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ONE+ PSBDD01 and is the answer not in the manual?
Questions and answers
My 1/2" PSBDD01 works for a few minutes then when I stop the drill the light stays on steady but the drill won't work again without removing and replacing the battery
The issue is likely due to the tool overheating. The Ryobi ONE+ PSBDD01 drill has a high temperature protection feature that deactivates the tool when it overheats. If the LED light flashes more than 9 times, the battery must be removed and reinserted after a few minutes to restart the tool.
This answer is automatically generated
@Mr. Anderson - I can't believe it is overheating. The LED light comes on when I start the drill as usual, but no matter hlw long I drill (10 seconds or extended time) when I release the trigger the light doesn't go out and trying to drill again doesn't start it back up. If I don't R&R the battery, the light stays on and doesn't stop until the battery is removed and replaced(R&R).
There is no page 11 !? The manual specifies that figure 8 is on page 11.