Engine Coolant - MARUTI SUZUKI Dzire Manual

INSPECTION AND MAINTENANCE
NOTICE
To tighten the oil filter properly, it is
important to accurately identify the
position at which the filter gasket
first contacts the mounting surface.
5) Tighten the filter as specified below
from the point of contact with the
mounting surface (or to the specified
torque) using an oil filter wrench.
Tightening torque for oil filter
3/4 turn or 14 Nm (1.4 kg-m, 10.3 lb-
ft)
NOTICE
To prevent oil leakage, check that the
oil filter is tight, but do not over-
tighten it.
Refill with oil and oil leakage check
1) Pour oil through the filler hole and
install the filler cap.
For the approximate capacity of the oil,
refer to "Recommended fuel / lubricants
and capacities (approx.)" in "SPECIFI-
CATIONS" section.
2) Start the engine and carefully check the
oil filter and the drain plug for leakage.
Run the engine at various speeds for at
least 5 minutes.
3) Stop the engine and wait about 5 min-
utes. Check the oil level again and add
7-9
oil if necessary. Check for leakage
again.
NOTICE
• When replacing the oil filter, it is
recommended that you use a MAR-
UTI genuine replacement filter. If
you use an aftermarket filter, check
that it is of equivalent quality and
follow the manufacturer's instruc-
tions.
• Oil leakage from the periphery of
the oil filter or drain plug indicate
incorrect installation or gasket
damage. If you find any leakage or
are not sure that the filter has been
properly tightened, have the vehi-
cle inspected by an authorised
Maruti Suzuki workshop.

Engine coolant

Selection of coolant
To maintain optimum performance and
durability of your engine, use MARUTI
genuine coolant or equivalent.
This type of coolant is the best for cooling
system for the following reasons:
• The coolant helps maintain proper
engine temperature.
• It gives proper protection against freez-
ing and boiling.
• It gives proper protection against corro-
sion and rust.
Failure to use the proper coolant can dam-
age your cooling system. An authorised
Maruti Suzuki workshop can help you
select the proper coolant.
56RH0-74E