Pager Programming - JTECH SmartCall IQ User Manual

Pager Programming

Set Pager Alert Type (Factory Default: FLASH & VIBE)
Use this feature to change the way your pagers alert the guest / patron. Be sure that all pagers are returned before
performing this procedure.
To change the Pager Alert, follow the procedure below:
1. Remove all the pagers from the chargers or unplug the power supply that is connected to the charging bases.
2. At the "Set Pager Alert" menu, press the "#/SELECT" key to scroll through the different alert options.
3. After making a selection, press the "ENTER" key 3 times. After sending the code, the pagers will now respond
with your new selection.
4. Press "CANCEL" key twice to exit the programming menu.
5. Return all pagers to the charging base or plug the power supply back in. The pagers are ready to receive the
page with the new alert.
Set Pager Alert Time (Factory Default: 60 Seconds)
This will allow you to change the alert time to fit your needs the most.
To change the Alert Time, follow the procedure below:
1. Remove all the pagers from the chargers or unplug the power supply that is connected to the charging bases.
2. At the "Set Alert Time" menu, press the "#/Select" key to scroll through the different alert options.
•
8 seconds
•
15 seconds
•
30 seconds
•
60 seconds
•
120 seconds
•
180 seconds
•
Continuous
3. After making a selection, press the "ENTER" key 3 times. After sending the code, the pagers will now respond
with your new selection.
4. Press the "CANCEL" key to exit the system programming menu.
5. Return all the pagers to the charging base or plug in the power supply. The pagers are ready to receive the
page with the new alert time.
800.321.6221
User Manual
IStation with Keyboard
6