Artcobell Discover Installation Instructions

Teacher desks

DISCOVER | INSTALLATION INSTRUCTIONS

SHIPPING



All teacher desks ship

upside down.

1. Unbox pedestal and place with glides on floor. Unbox mounting plate making sure to place the two (2)

included bags of screws in an easily accessible area. Align eight (8) mounting plate holes with

corresponding holes in the spacer board attached to the pedestal. Use #10 x .75" flat head screws to

attach mounting plate to pedestal spacer.

2. Place DTDT worksurface face down on padded surface.

3. If post legs were ordered, place legs in quickset plates and insert three (3) #12 x .75" pan head screws per

leg (included)

4. If a t-leg was ordered, follow instructions in t-leg carton to assemble leg.

01.20.16 | Rv1 | CC2125

Teacher Desks

 CAUTION

Pedestals are heavy.

Always use a minimum of

two people when

handling.

Table of Contents

Do you have a question about the Discover and is the answer not in the manual?

Page 1 DISCOVER | INSTALLATION INSTRUCTIONS Teacher Desks SHIPPING  CAUTION  All teacher desks ship Pedestals are heavy. upside down. Always use a minimum of two people when handling. 1. Unbox pedestal and place with glides on floor. Unbox mounting plate making sure to place the two (2) included bags of screws in an easily accessible area.
Page 2 DISCOVER | INSTALLATION INSTRUCTIONS a. Once assembled, remove quickset plates from DTDT worksurface. b. Align t-leg with predrilled holes and attach to worksurface with #12 x .75” pan head screws (included) 5. Using two (2) people, flip table and rest on pedestal while aligning four (4) mounting holes. Attach pedestal with #12 x .75”...
Page 3 DISCOVER | INSTALLATION INSTRUCTIONS Caster Option (From page 1, Follow Steps 1-2 first) 1. For caster option, locate included caster package 2. For pedestal casters, locate notches in each corner of pedestal bottom. Pedestal Casters - Front Pedestal Casters – Rear 3.