Advertisement
INSTALLATION INSTRUCTIONS
Tops and Legs ship in separate cartons
1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching.
2. Place the triangular Leg Plate on the top and slide beneath the Quick-Set Bracket in the direction shown in
Figure 1.
NOTE: A plastic or rubber mallet may be used to lightly tap the leg beneath the Quick-Set Bracket. In the
event that the triangular Leg Plate does not slide underneath the Quick-Set Bracket with light tapping
of the mallet, the screws identified "A" in Figure 1 below may be slightly loosened and then
retightened to enable the triangular Leg plate to slide beneath the Quick-Set Bracket.
Use mallet here to lightly tap leg
plate beneath Quick-Set Bracket
Slide leg plate in this direction
Leg Plate
03.26.15 | Rv3 | CC2105
Activity Tables
Quick-Set Bracket
"A" - (5 places)
Figure 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Artcobell Uniflex 1200 Series
Summary of Contents for Artcobell Uniflex 1200 Series
- Page 1 INSTALLATION INSTRUCTIONS Activity Tables Tops and Legs ship in separate cartons 1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching. 2. Place the triangular Leg Plate on the top and slide beneath the Quick-Set Bracket in the direction shown in Figure 1.
- Page 2 INSTALLATION INSTRUCTIONS With the Leg Plate now fully seated underneath the Quick-Set Bracket, install (3) Philips head, #10 x ¾” screws provided in the hardware pack in the 3 holes identified “B” as indicated below in Figure 2. “B” - (3 places) Figure 2 Adjust leg to desired height by loosening the two 5/16”...
Need help?
Do you have a question about the Uniflex 1200 Series and is the answer not in the manual?
Questions and answers