Advertisement
ALPHABET | INSTALLATION INSTRUCTIONS
Applicable Base Models:
ATT
Tops
ATLI Leg Kits
1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching
2. Align the leg assembly keyholes with the 4 shoulder screws as shown below in Figure 1.
Shoulder Screw
With the I-Leg assembly now placed over the shoulder screws, slide the leg assembly in the direction indicated
3.
below in Figure 2. (IMPORTANT – SEE NOTE ON REVERSE SIDE)
Start Position
02.12.15 | Rv3
I-Leg Assembly Keyhole
Table Tops and Leg Kits | I-Leg
Slide I-Leg Assembly
Final Position
Figure 2
Figure 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Artcobell Alphabet
Summary of Contents for Artcobell Alphabet
- Page 1 ALPHABET | INSTALLATION INSTRUCTIONS Table Tops and Leg Kits | I-Leg Applicable Base Models: Tops ATLI Leg Kits 1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching 2. Align the leg assembly keyholes with the 4 shoulder screws as shown below in Figure 1.
- Page 2 ALPHABET | INSTALLATION INSTRUCTIONS NOTE: Some resistance sliding the I-Leg Assembly to its final position may be encountered. This should be considered normal. Use of a plastic or leather mallet to aid assembly is permissible if used as shown below in Figure 3.
Need help?
Do you have a question about the Alphabet and is the answer not in the manual?
Questions and answers