Philips NT3160 User Manual page 27

ow
hair
ing
ng
g
ear/
the
se
NT3160-10̲A7̲JP̲cs6.indd 26
Cleaning
Clean the appliance immediately after use and
when a lot of hair or dirt has accumulated on the
cutting element.
Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as
petrol or acetone to clean the appliance.
Do not tap on the cutting element.
Do not use any sharp objects to clean the cutting
element.
Make sure the appliance is switched off.
1
Rinse the cutting element of the nose/
2
ear/eyebrow trimming head with hot
water (Fig. 15) .
Switch on the appliance and rinse the cutting
3
element once more to remove any remaining
hairs. Then switch off the appliance again.
Tip: The best way to clean the cutting element is
to immerse it in a glass with warm water for a few
minutes and then switch on the appliance (Fig. 16) .
ENGLISH
26
14/12/08 14:08