Setting Up - RIDGID AC9940 Owner's Manual

• If a slide compound miter saw is already
assembled to the stand, follow the
above steps plus slide the head/blade
assembly to the front of the saw and
lock the slide rails.

Setting Up:

1. From the upright position, hold the leg
cross bar and pull the locking pin.
2. Lift legs up until the pin locks in place.
3. Lower unit until the legs rest on the floor.
4. Stand at wheel end of unit, grasp the lift
handle/lock lever. Squeeze lock lever
and raise the table to a position just
above horizontal.
CAUTION: Do not lift by any part
of the miter saw that is attached
to the workstand. Tool may be
damaged.
CAUTION: When lifting, bend
your knees so you can lift with
your legs, not your back.
5. The sliding legs will follow tracks on the
underside of the table to their engaged
position near the handle end of the
table.
6. Return table to horizontal position. The
table should now rest firmly on top of
the sliding legs. If not, repeat "pull up
and set down" motion.
7. Release lift handle/lock lever.
NOTE: You may need to adjust the speed
at which you raise the table in order to get
the sliding leg to catch in the notch.
WARNING: To reduce the risk of
injury, make sure sliding leg is
secured in the notch by the lock
lever. Failure to latch may cause
stand to fall in use.
Leg
Crossbar
Spring Pin
Knob
Sliding Leg
7
Pull Locking
Pin
Lift Handle/
Lock Lever