Extension Bar(S) Operation - RIDGID AC9940 Owner's Manual

Extension Bar(s) Operation

Both extension bars may be adjusted to
provide maximum workpiece support. To
adjust the extension bars:
1. Unlock adjustable handle.
NOTE: Adjustable handle can be reposi-
tioned if necessary. Lift up on lever and
rotate to desired position then release
lever.
2. Slide out extension bar to desired set-
ting and lock extension bar lever.
NOTE: There is a catch to limit the overall
extension bar travel.
3. Pull out on locking pin knob and swing
leg down.
4. Turn foot knob counterclockwise to
loosen and slide foot extension down
until fit contacts the floor. Tighten foot
knob.
5. Repeat for other extension bar.
NOTE: It may be necessary to realign
roller assemblies with the miter saw table.
See Mounting and Aligning Roller Assem-
blies.
Locking
Pin Knob
Leg
Foot
Knob
11
Adjustable
Handle